Tape the end of the metal wire that is running up the column to the new wires, then pull the new wires down through the column, occasionally giving it a push in as you progress. Installing the turn signal switchīefore you begin feeding the new switch wiring into the column you should unscrew the steering wheel collar from the top of the column, this will make it easier to pull the wires through. Tape the wires together to keep them together and protected while you install the wires into the steering column. Do one at a time and make sure you can remove it, then put it back in place so you can match them up with the new wires when you ready to install the connector onto the new wires. To remove the old wires you need to compress the tab on the end of the wire so you can pull it out of the connector.Ĭompress the tab on each wire at the bench. The old wires will need to be removed from the factory connector housings so you can install the new wire ends into them after the switch is installed. Prepping the new switch and connectorsīefore you begin any installation or repair you should always compare the new parts to the old parts to make sure you are about to install the correct part. You will tape the new switch wires to the metal wire and then pull them through the column, which is a lot easier than trying to push them through the column. Make sure the wire is long enough to pull up through the column and have about 12 inches or more remaining at the bottom of the column where the wires exit. You should tape a piece of metal wire to the cut ends of the wiring before you pull out the switch. Then remove the spring from the shaft and unscrew the turn signal arm by hand or with an open end wrench on the flat spot if its too tight.īefore you can remove the turn signal switch you will need to unplug the connectors and cut the wires that come out of the steering column near the brake peddle.Īfter cutting the wires you can now unscrew the turn signal from the column, remove the metal plate that sits on top of the switch base and then pull the switch and wiring out through the steering column. Then use the steering wheel puller to pull the wheel of the steering shaft. Remove the nut that secures the wheel to the steering shaft with a 1/2 ratchet or breaker bar and an appropriate sized socket. The steering wheel will most likely need to be removed with a steering wheel puller so plan on having one available other wise you will not be able to complete the replacement. If you perform this and your horn is blowing then you missed the step above. Removing the horn button is as easy as pushing down on the center of it and then giving it a twist counter clockwise. Always disconnect the battery ground or negative cable first, this will spare you the “shock” you may experience if you grounded out the wrench while disconnecting the positive side.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |